Skip to content
(787)-476-7950 Hormigueros, PR 00660

Mon – Fri 7:00 am – 5:00 pm OPEN Saturday-Sunday CLOSED

Two GlobalTech technicians checking a network rack with patch cables, one holding a laptop

GlobalTech Corp.

Structured Network and Data Cabling for Businesses in Puerto Rico

GlobalTech Corp., a Leviton Authorized Network Installer, designs, installs and certifies structured network cabling (Cat5e, Cat6 and Cat6A copper, plus fiber backbones) for offices, warehouses, clinics, schools and factories across Puerto Rico from its office in Hormigueros. It is also CommScope Netconnect Certified, and its installations are tested and certified with Fluke equipment, which measures each link against its category instead of only checking that it connects.

On the island, a cabling plan also has to answer to hot ceilings and telecom rooms, salt air on runs between buildings, power cuts that can darken every device powered through the cable, and hurricane seasons that make accurate records worth having.

  • Leviton Authorized Network Installer
  • CommScope Netconnect Certified
  • Installations tested and certified with Fluke equipment
  • Cat5e, Cat6 and Cat6A copper, plus fiber backbones between floors and buildings
  • MDF/IDF buildouts, patch panels, cable management and grounding
  • OSHA 10/30 safety compliance for work in operating plants and hospitals

Heat, humidity and salt air: what they do to cabling here

Above a drop ceiling under a concrete roof, the afternoon air is much hotter than in the office below, and a telecom closet whose air conditioning shuts off at night or over a long weekend sits in heat and humidity for hours. Copper cable is rated for a maximum temperature, and bundles that carry PoE power to access points, cameras and phones add heat of their own. A sound route keeps bundles modest and supported, away from the roof slab and from hot equipment, so the cable stays within its temperature rating.

Humidity works on the metal: jack contacts, patch panel terminations and the rack itself. The equipment room deserves its own plan for cooling, airflow and grounding, which is the work of network cabinets and server room buildouts.

Near the coast, salt air shortens the life of anything left outdoors. Runs between buildings call for outdoor-rated cable in sealed conduit and boxes, and often for fiber instead of copper.

Power cuts and storms: planning for the day after

Wi-Fi access points, IP cameras and VoIP phones usually take their power through the data cable from a PoE switch. If that switch is not on a UPS, a power cut darkens all of them at once: no phones, no Wi-Fi and no recording at the moment the building is most exposed. Plan the switch, its UPS battery backup and the cabling as one design, and size the UPS for the PoE load, not only for the switch. The surges that can come when power returns are one more reason to bond and ground the racks properly.

Storms also test the paperwork. When a ceiling has to come down after water gets in, or a room is rebuilt, labels that match at both ends and a plan of where each cable runs tell whoever does the repair which link feeds which desk, camera or access point. Without them, every cable has to be traced by hand before anything is reconnected.

How a cabling project runs with GlobalTech

  1. Site visit. A walk through the space to look at ceilings, walls, the spot for the rack or network cabinet, and any route between floors or buildings.
  2. Count of drops and pathways. You agree on how many data points go where (desks, phones, cameras, access points), the cable category (Cat6 or Cat6A) and the path each run takes to the rack.
  3. Installation. Cable runs, terminations on patch panels, cable management and grounding, with OSHA 10/30 safety compliance when the work happens inside an operating plant or hospital.
  4. Fluke certification testing. Each installed link is tested with Fluke equipment against the performance its category requires.
  5. Handover. The finished installation is handed over; the next section lists the records to ask for at that point.

What to ask for at handover

A certified installation should leave you with more than working jacks. Certification testing produces a report for every link, and that report is the core of the handover; labeling and as-built records are worth writing into the scope before work starts:

  • Test results for each cable: the Fluke report of every link, measured against its category. Keep it: it is the proof of what was installed and the baseline for any later repair.
  • Labeling: the same identifier on the wall plate and on the patch panel port, so any cable can be found from either end.
  • As-built records: the floor plan updated with where each data point ended up and which panel it lands on.

With those three, adding a camera, moving a desk or handing the network to a new IT provider no longer starts with guesswork.

Who it is for on the island

  • Offices, retailers and clinics adding desks, moving to a new space or replacing old Cat5e before a network upgrade.
  • Hospitals and factories that cannot stop, where installers work around patients, production lines and safety rules.
  • Warehouses and industrial facilities with long runs to access points and cameras mounted high on shelving and walls.
  • Hotels and schools whose Wi-Fi depends on a cable to every access point; see UniFi Wi-Fi networks in Puerto Rico.
  • Federal and compliance-driven organizations that need their network documented.
  • Companies based on the mainland with a plant, warehouse or office on the island that need a local installer and records their own IT staff can read.

Frequently Asked Questions

Do you install network cabling outside western Puerto Rico?

Yes. GlobalTech installs cabling across the entire island, so a building in Bayamón, Arecibo or Humacao goes through the same site visit, drop count and Fluke testing as one next to the Hormigueros office. For planning, the building matters more than the town: say whether the ceiling is still open or already finished, whether the space will be occupied during the work, and whether any run leaves the building. To ask for the visit, use the contact page.

Who certifies the cabling, and what should I have ready for a quote?

GlobalTech is a Leviton Authorized Network Installer and CommScope Netconnect Certified, and the installation is certified link by link with Fluke test equipment. For the quote, have a floor plan if one exists, a count of desks, phones, cameras and access points, and the spot where the rack or network cabinet will go. If the building is near the coast or needs runs between buildings, say so as well.

Should a run between two buildings near the coast be copper or fiber?

Usually fiber. A copper Ethernet channel is limited to 100 meters (328 feet), and a copper run between buildings gives a surge or a nearby lightning strike a metal path from one building to the other. Fiber carries light, not electrical current, and covers far longer distances. Either way, the run needs outdoor-rated cable and sealed entries at both buildings, since salt air corrodes exposed connectors and hardware. See fiber optic backbone installation.

What should we check in our cabling after a hurricane or a flood?

Start where water or wind got in: ceilings, telecom rooms, outdoor runs and anything at floor level. Cable that sat in water, jacks with corrosion and boxes that filled up need attention even if the network seems to work. If the original Fluke results exist, the affected links can be tested again and compared with them, which separates the cables that need replacing from the ones that only need a new termination.

Can the cabling for cameras, Wi-Fi and phones be done in the same project?

Yes, and that is the right moment. The runs for Wi-Fi access points, IP cameras and VoIP phones are part of a structured cabling job: they are counted in the same plan as the desks, land on the same patch panels and pass the same Fluke tests. Counting the PoE devices at this stage also sizes the switch, and the UPS that keeps them running through short power cuts. The cameras themselves are covered under security cameras for businesses in Puerto Rico.

More on this topic

For the full list of what the cabling service includes, see the network cabling service page. If you are comparing Cat6 and Cat6A, planning distances or reading a test report, the structured cabling guide explains it step by step. Coverage, office hours and how to request service are on the Puerto Rico service area page.

Send the request with your phone number

and we will call you back.